                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:2963466
Super Heavy APC "Lacedaemon" by woddish is licensed under the Creative Commons - Attribution - Non-Commercial license.
http://creativecommons.org/licenses/by-nc/3.0/

# Summary

A Super Heavy APC from the interstellar civil war period.
Big edit to this model. Went back and re-did some of the finer details so that they will show better after printing. Also re-cut the parts after seeing the amazing print job graudnov achieved with their edit of my Armoured Triton model, https://www.thingiverse.com/thing:3605172 . 
Parts are now cut so that they can be printed flat on the print bed and will then attach to a simple center block piece through the use of pegs. Two different length pegs are included. The small pegs connect the nose, engine, and top to the center block. The long pegs connect through the side pieces. The smokestacks are now separate from the engine part. They have built in little square pegs that will slot into the engine. This will allow them to be printed vertically.
You will need 2 of each track piece (outside, inside, and core) and 2 sponsons, and they WILL need to be mirrored. 
You will need 2 quad and 2 sponson pins, they WILL NOT need to be mirrored. 


I'm looking for any feedback you may have and would love to see pictures of prints!
Thank you.