                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:3301512
Thunder Lightning Heavy Fighter Bomber by Tazdevilal is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
http://creativecommons.org/licenses/by-nc-sa/3.0/

# Summary

This is a remix of parts from the two original designs shown.
However for the main body and the front section I had to do quite a bit of work in 3D builder (only software I know how to work unfortunately) fixing badly resolutioned areas and also areas of the build that just printed out VERY badly.
The end result actually is coming out quite good with the main body parts being printed on my CR10 and the smaller parts and front section being printed on my Ender 3 Pro.

.2mm for the CR 10 using S3D
and 
0.1 for the ender pro on Cura V3.6

In total I've been able to produce one of these fully made on the 2 machines over the course of around 11 hours give or take which s not too bad for me.

Working on changing the print orientation of the Main body to eliminate almost all need for supports.

# Print Settings

Printer Brand: Creality
Printer: CR-10S
Rafts: Yes
Supports: Yes
Resolution: .2mm and .1mm
Infill: 20%
Filament_brand: none
Filament_color: grey
Filament_material: PLA