                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:3197916
Immolator tank by GunnarUK is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

This is my version of a tank used by the sisters of battle, the immolator.  This is a work in progress and is not complete, I am working on a turret for it.  Only to be used to practice colour schemes and test how it plays, dont not sell or trade.

It is based upon a design I found on thingiverse for the rhino chassis, I cant remember who did it but I have had it for ages and changed and tweaked a few bits., So thank you to whoever you are.

I have printed this and it looks ok so far, just the turret to do, I plan on using a few bits from ebay to make the flamers for it, just so they look better.  I hope the leman russ flamers will do the job.  Also going to add a figure to man/woman the flamers.

# Print Settings

Printer Brand: Creality
Printer: CR-10S
Rafts: No
Supports: Yes
Resolution: .2mm
Infill: 15%
Filament_brand: fileaprint
Filament_material: PLA

Notes: 
I print with a brim because I hate curly corners, if you have good adhesion you may do what works for you.  I shall upload some pics once I have printed what I need and start to paint.

the L view port and s view port didn't print well when on the top piece so I did them separately and glue them on after. I put 4 x s view port on the front 4 positions and 5 x L view ports around the back.
L is Long, s is short btw.